# Squash Court Line Marking Tape

Learn how squash court line marking tape defines the front wall, back wall and service box lines, and how to apply it on glass and wood courts.

Squash [court line marking tape](/articles/floor-marking-tape-for-game-boundaries/) is an adhesive strip used to lay out or restore the painted boundaries of a squash court, including the service box lines and the out-of-court line. It gives players a visible edge to judge where the ball lands and where a serve must cross. This page explains what the tape marks, how it behaves on glass and wood courts, and how to apply it so the lines stay readable during play. 

## What the tape marks on a court 

Squash court line marking tape traces the playing boundaries that players use to call a ball in or out. The front wall and back wall lines set the vertical limits, while the service box lines divide the floor into serving areas. A separate out-of-court line shows where the ball has left the legal playing area. Tape is laid over the floor and wall surfaces rather than painted into them. 

## Tape on glass and wood courts 

Tape on glass and wood courts must grip a smooth, low-porosity surface that paint does not easily accept. Glass panels and finished wood floors shed dust and moisture, so the surface needs a clean, dry wipe before any strip goes down. A tape rated for smooth surfaces holds its edge better than a general-purpose strip. On glass walls, the tape marks the front wall boundary without damaging the panel. 

## Applying tape so lines stay true 

Applying squash court line marking tape starts with measuring each boundary against the court dimensions before any strip is cut. A chalk line or a straight edge keeps the run true, and the strip is pressed down along its full length rather than only at the ends. Air bubbles and lifted corners catch a ball and peel, so the tape is smoothed from the center outward. Corners where two lines meet need a clean overlap so the boundary reads as one continuous edge. 

## Questions about squash court marking tape 

### Can squash court line marking tape be used on glass walls? 

Yes, squash court line marking tape can mark glass walls when the strip is rated for smooth, non-porous surfaces. The glass must be clean and dry before the tape goes down, because dust and finger marks stop the adhesive from bonding. A tape that lifts at the edge will not stay true through play, so press the full length firmly. 

### Does the tape replace painted squash court markings? 

Squash court line marking tape can replace painted markings where a court needs a quick layout or a temporary boundary. Tape sits on top of the surface, so it wears and can be removed or replaced without repainting the floor. A permanent painted line still suits a court that stays in one configuration, while tape suits a layout that changes. 

### Which lines does the tape need to cover? 

Squash court line marking tape should cover the front wall and back wall lines, the service box lines and the out-of-court line. Each boundary tells players where a serve must land or where the ball has gone out. Leaving one line off makes a call unclear, so the full set of squash court markings is laid out together. 

### How do you keep tape lines straight on a wood floor? 

Squash court line marking tape stays straight on a wood floor when each run is measured and marked before the strip is cut. A chalk line or straight edge guides the tape, and the strip is pressed from the center outward to push out air. Wood floors should be clean and dry, since grit under the tape shortens how well it holds.
